Remove motor oil and grease from a variety of surfaces without scrubbing.
It is safe to use inside and out due to its eco-friendly formula. Effortlessly remove oil stains, grease and mold from work surfaces, parking lots, gas pumps and more. Use DRIVE UP on asphalt, concrete, wooden decks, tiles and stone. DRIVE UP Super Cleaner has the ability to literally “drive up” an oil stain, not only from the surface of concrete, but also from beneath the surface, so that your stain does not reappear after a few days.
DRIVE UP cleans the following:
Parts and Fittings
Tools and Equipment
Oil Separation Units
Concrete Floor Cleaning Directions
Read label Directions and use according to label directions
Use recommended protective gear
Liberally apply DRIVE UP onto the dry soiled concrete floor, do not Pre-Wet the Concrete Floor.
For larger areas DRIVE UP Super Cleaner can be applied through a Garden Sprayer.
Allow to soak for at least three hours. You can re-apply Drive–Up Super Cleaner during this time.
For the most difficult oil and grease stains allow DRIVE UP Super Cleaner to stay on the concrete floor or stained area of the floor overnight.
Rinse the cleaner off the concrete floor with a garden hose and nozzle or for faster results you can use a high pressure washer to rinse the cleaner off the floor.
Repeat as needed, the oil needs time to be "driven up" to the surface, for permanent removal.
A smoother surface will need less time than a rough surface.
Replace all your conventional cleaning agents with ONE CLEAN Super Cleaner. The powerful concentrated degreasing agent is non-toxic and biodegradable, ensuring a safe but effective cleaning solution. The non-corrosive cleaner can be used on any surface without risk of abrasion, and without cumbersome personal protection equipment. Removes grease and grime with ease!
Ovens Full strength. Spray onto warm oven, wait 5-10 minutes, scrub with green pad, rinse with clean water.
Grills Full strength. Clean while still HOT, but turned off. Leave hood fan on. Spray on entire grill surface. Pour small amounts of water on the grill, while scrubbing with a pot brush, then rinse with water.
Hoods, Walls, Restrooms, etc Dilute 4 oz. OneClean plus water to fill a spray bottle, spray on, wipe or rinse off.
Fryer Boil-out Drain fry oil, pour 1 gallon of OneClean into the oil vat and fill with water to the “oil fill” line. Wear gloves, apron and eyewear to avoid splash and steam. Boil for 1 hour, then drain. Scrub with green pad, and then rinse twice with water.
Walkways Mix 8 oz. OneClean per gallon of HOT water in a bucket. Pour onto walkway, scrub and rinse.
Tile Floors Industrial Kitchen Floors, Bathroom & Shower Tiles Mix 1 oz. OneClean per gallon of water, damp mop, rinse with clean hot water.
Concrete & Asphalt Drive-Thru’s, Parking Stalls, Parking Lots, Gas Station forecourts Full strength for heavy soil. Mix with equal amounts of water for light soil, apply to dry pavement, do not wet surface first. Soak for at least 3 hours, rinse.
General Degreasing Walls, Trash Receptacles, Signs, Coolers, Shelves, Bars, Tables, Chairs, Pool Decks, Patio Furniture and more HEAVY SOIL - full strength in spray bottle. LIGHT SOIL - 4 oz. OneClean plus water to fill a spray bottle. Spray on, then wipe or rinse off.
To clean your broiler grid, scour in one direction only. Grillmaster Grill Cleaner “grooves” itself to the rods of the grill grid.
Cleans griddles and grills uniformly, leaves no sulphurous odor or taste. Lasts up to six times longer than other grill stones.
Cleans through abrasive action. Always use brick in the presence of water or oil.
Charcoal and Gas Barbecues
To clean hard metal and porcelain fire boxes, covers and grill and broiler racks: wet brick. Rub surface to be cleaned using gentle pressure. Rinse or wipe cleaned surface of residue. Your Grillmaster Grill Cleaner will shape to flat or curved surfaces. "Grooves" itself to cooking grids.
Pancake and Fry Griddles
Coat warm but not hot griddle with cooking oil. Scour griddle using flat side of stone. Work in one direction. To keep oil cure and prevent sticking, clean only carbon and food from griddle. Wipe cleaned surface of residue with dry cloth.
DO NOT USE on unbaked enamel finishes, plastic coated surfaces and soft or highly polished metals. Some decorator tile and colored porcelain is fragile and may be damaged by abrasive cleaning materials. When in doubt, test a small area before proceeding.
1. Pour or leave liberal amount of cooking oil on warm (not hot) grill plate. 2. Sprinkle with generous amount of salt for perfect cleaning. 3. Scour in one direction only with the surface of Grillmaster. 4. Scour ONLY until all burned food and carbon are removed. Scouring to high polish may remove cure and cause sticking. 5. Clean corners with smaller pieces of used Grillmaster. 6. Wipe with clean dry cloth. 7. Use Grillmaster aluminium holder to prevent burned fingers.
Magnesol XL Fry Oil Filter Powder Directions For Use
More info Coming
*Filter oil a minimum of one time per day, when most convenient for your operations *Use a fresh piece of filter media and MAGNESOL® filter powder before starting the filtration process *Be sure to circulate the oil for at least 5 minutes during the filtration process *Use a tracking sheet to track your daily filtration & disposal habits *The decision to discard oil should always be made after the fryer is filtered
Step 1: Soak Buffalo Eraser Sponge with Water Step 2: Squeeze out Excess Water Step 3: Clean, Scrub, and/or Degloss Target Area Step 4: Rinse and Repeat as Needed Step 5: Wipe and Dry Area with Clean Cloth Always test on a hidden area prior to use because both sides of the Buffalo Eraser Sponge can scratch, mar, or dull some surfaces.
ALWAYS WET BEFORE USE
The Buffalo Eraser Sponge cleans most surfaces with just water. The sponge side of the Buffalo Eraser Sponge is an extremely fine micro-abrasive foam. This quality greatly enhances the cleaning and preparation characteristics of the Buffalo Eraser Sponge. The woolly side of the Buffalo Eraser Sponge is a non-abrasive nylon and can be used a like a standard nylon scrub. The sponge side MUST BE DAMPENED before use.
USE COMMON SENSE
Do not let your kids (or pets) play with or use Buffalo Eraser Sponges! They can be swallowed and can cause rashes and burns if rubbed against the skin. After using, wipe up any remaining residue. Don't eat, lick or taste. Don't rub on your person. The superfine foam can cause abrasions. Do not use on chrome, glossy automobile paint or high gloss surfaces. Use lightly on painted walls. Melamine is a micro-abrasive and can scratch some surfaces. Always test on a hidden area prior to use. Use caution on leather and other dyed surfaces. Do not use the melamine side (white side) of the Buffalo Eraser Sponge on uneven or rough surface. This could cause the sponge to shred.
Learn more by watching these Super Cleaner Videos
Navigate To Our Other Favorite Products:
What else do you want to clean?
Our Amazing Super Safe Chemicals & Accessories Can Do It All!